Introduction
This guide outlines the procedure for replacing a leaking rear axle seal, specifically addressing concerns about needing to replace the entire hub assembly.
Problem
Oil leak detected at the rear wheel, suspected to be from the rear axle seal.
Solution
The rear axle seal can be replaced independently of the entire hub assembly.
Procedure
- Drain the differential oil.
- Unbolt and remove the brake caliper.
- Remove the brake disc.
- Remove the four bolts holding the axle carrier flange to the axle tube.
- Slide out the axle carrier flange. This will expose the axle seal.
- Replace the axle seal.
- Replace the O-ring between the axle tube and the flange.
- Reassemble.
Additional Considerations
- While disassembling, inspect the handbrake shoes and brake pistons for wear or damage and replace if necessary.
This technical summary was auto-generated based on recovered archives. Do not rely on its factual accuracy. Refer to the original thread. Source: View Original Conversation
Continue the discussion below.