Introduction
This article details the compatibility of a genuine Toyota towbar from a 97 series Prado with a 99 series Prado.
Problem
The user wanted to know if a genuine Toyota towbar from a 97 series Prado would directly fit their 99 series Prado “Snowy” model.
Solution
The towbar will bolt to the chassis rails using two bolts on each side.
- The front bolt utilizes a pre-threaded factory hole.
- The rear hole requires drilling. A tapping bar (also referred to as a ‘nut bar’) is inserted inside the chassis rail for the bolt to thread into.
IMPORTANT: There are two possible hole spacings: 190mm centers and 110mm centers. Inspect the rear section of the chassis rails to determine the correct spacing for your vehicle.
DIY Installation: Installation is possible as a DIY project. The existing factory bolts will hold the towbar in position while the rear holes are drilled.
Relevant Parts and Installation
- Wiring Harness: A plug-and-play wiring harness is available from Toyota. This harness connects to a socket located near the jack, under the left rear plastic panel.
- Additional Wiring: If electric trailer brakes or an Anderson plug are required, additional cabling will need to be run separately.
This technical summary was auto-generated based on recovered archives. Do not rely on its factual accuracy. Refer to the original thread. Source: View Original Conversation
Continue the discussion below.